Filtering the view of the data

Previous  Top  Next

In a large application it can be difficult to determine what program controls do not have a match in the Ezhelp data file.

To filter the comparison, click the Ezhelp Mismatch Only filter button:


This will filter your view of the data to show only controls that do not match.

A mismatch can be caused by one of two conditions:

·	The Ezhelp entry does not exist (usually because you added controls AFTER you ran the initial export to Ezhelp)

·	The Ezhelp entry is different than the tooltip in your application (usually because you have edited the Ezhelp entry in the Ezhelp tip editor)

If you have mismatched entries, they will be the only items displayed: